RightWay GPS Navigator RW 430 Guía de usuario descargar pdf (Pagina 56)

7 Automatically Setting up a Mobile Base Station Using AutoBase Technology

GPS RTK Base GPS Receiver User Guide

8. The antenna type, antenna height, and measurement method

used in the previous setup of this base station are applied.

CAUTION – If the antenna height is different from the previous setup,

then you must enter the corrected height for the antenna (using the

keypad and display) before starting measurements. Failure to achieve the

correct antenna height position for the antenna results in errors in heights

in subsequent measurements.

9. The receiver begins generating RTK CMR+ corrections.

10. The RTK corrections begin streaming on the radio or port defined

in the previous setup of this base station.

Note – AutoBase recalls base station positions that are stored in the

receiver. If the receiver has been previously set up on a control point but the

stored base station position is not found in the receiver, it is possible that

the information may have accidentally been deleted. In this case, use the

display and keypad to manually set up the base station. Make sure that

you use the same base station latitude, longitude, and height as in the

previous setup otherwise you will experience position or height errors in all

subsequent measurements.

Trimble recommends that after any new base station setup, or at the start

of each measurement session, you measure a known point to verify that

position and height errors are within tolerance. This is good practice and it

takes just a few seconds to eliminate potentially gross errors typically

associated with repeated daily base station setups.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 93 94

Sin comentarios

RightWay GPS Navigator RW 430 Guía de usuario Pagina 56